Radio, Stereo, and Compact Disc: Service and Repair

Removing And Installing The Car Radio

Removing the car radio
1. Remove the car radio with special tool 9570/1.







2. Engage the special tool to the right and left in the slits provided in the car radio.
3. Carefully pull the car radio out of the holder using the special tools and disconnect the electrical plug connections.

Installing the car radio
1. Remove the heating/air-conditioning control.
2. Engage the electrical plug connections on the car radio.







3. Pull the special tool out of the car radio by pressing gently on the retaining spring -arrow-.
4. Carefully push the car radio into place.
5. Through the opening on the heating/air-conditioning control, it is possible to check the position of leads in the support frame better and to prevent leads from becoming trapped.
6. Install the heating/air-conditioning control.

Entering the code number
1. If the car radio is disconnected from the power supply, it will be protected against theft the next time it is connected.
2. After being switched on with the -ON- key, the term -CODE- is displayed followed by 4 asterisks.
3. The four-figure code number must be entered using the multi-function keys 1...0.
4. Example: code number 1530 (the code number can be found in the enclosed -CODE CARD-). Enter the code number with the multi-function keys.
5. The first asterisk disappears after the first number is entered. The second asterisk disappears after the second number is entered, etc.
6. If the fourth number has been entered and all the other numbers were correct, the device switches itself on automatically.

INFORMATION: The -CODE CARD- must always be stored without fail outside the vehicle in a safe place. In this way, improper use can be excluded. The enclosed window stickers should be adhered to the inside of the vehicle windows.

7. If an incorrect code number has been entered, the term -CODE- will be displayed with the four asterisks once more.
8. If an incorrect code is entered three times, the term -WAIT- is displayed and the device is blocked for approx. 60 minutes.
9. Another three incorrect inputs block the device for an additional 60 minutes.
10. -IMPORTANT:- the waiting time only counts down when the device is switched on.

INFORMATION: The new code number should be entered in the Motronic, test step vehicle data, using the Porsche System Tester 2.