Procedures

Left / Right Traffic Conversion For Xenon Headlights

WARNING: Warning signs (yellow triangle with black high-voltage arrow) indicate high voltage (risk of fatal injury)! The light should always be switched off when the components (control module, gas discharge lamp, drive motor) are removed and installed. A removed headlight does not have a high voltage. The gas discharge lamp (D2S lamp) should only be operated when installed in the reflector and in the installed headlight.

INFORMATION:
- The masking film for left/right-hand traffic should not be removed from Xenon headlights.
- In the headlight there is a changeover lever for driving in countries with left- or right-hand traffic.
- The changeover lever is located on the left and right of the housing beside the gas discharge lamp.

Converting Xenon headlights
1. Switch off light. Remove main headlight.
2. Unscrew fastening screws (2 ea.) and open rear closure cap.







3. Put changeover lever into position T (tourist setting) using an 8 mm socket wrench insert.

Installation
1. Close cap and secure with fastening screws.
2. Install main headlight and perform a function test.
3. Repeat conversion for other headlight.