Installing Sealing Ring For Halfshaft Flange

Installing sealing ring for halfshaft flange





1. Fill the space between the dust and sealing lips with grease (e.g. Liqui-Moly) and drive in the sealing ring up to the mounting face with special tool pressure piece 9252.





2. Push in the halfshaft flange and tighten the fastening screw. If necessary, hold the halfshaft flange with 2 screws.
Tightening torque: 44 Nm (32 ft. lbs.).
3. Fitting the halfshaft flange on drive shaft
Tightening torque: 81 Nm (61 ft. lbs.).
4. Clip in the B-plus cable in the holder (only the right side).