Removing and Installing Multi-Function Remote Control

916119 Removing And Installing Multi-function Remote Control

Preliminary work

Preliminary work for multi-function remote control
Remove driver's airbag unit.

Removing multi-function remote control

Installtion Position Of Steering Wheel Shown On The 911:

NOTE:
- When removing the locking plate, take note of how many washers are used on each fastening screw.
- During installation make sure that the washers are fitted in the same way as they were before removal.

1. Unscrew the four fastening screws -1- on the locking plate in the steering wheel and remove along with the locking plate.

Removing The Locking Plate:

2. Use a screwdriver to carefully lever the multi-function control unit out of the steering wheel.

Removing Multi-function Control Unit:

3. Release electric plug connection -A- and disconnect it from the multi-function control unit.

Releasing Electric Plug Connection:

4. Unscrew the fastening screws -2- and washers -3- for the remote control and carefully lever the remote control out using a screwdriver.

Removing Remote Control From Steering Wheel:

5. Release the electric plug connection on the remote control -A- and disconnect it.

Releasing Plug Connection On The Remote Control:

6. Remove remote control.

Installing multi-function remote control
1. Insert electric connector into the remote control until it clicks into place.

Connecting Plug Connection On The Remote Control:

2. Insert remote control into the steering wheel, position washers -3- and screw down with the fastening screw -2-.

Installing Remote Control:

3. Attach electric plug connection to multi-function control unit until the plug clicks into place.

Clipping Multi-function Control Unit Into Steering Wheel:

4. Clip multi-function control unit into steering wheel. Check that it is secure.

NOTE:
- When removing the locking plate, take note of how many washers are used on each fastening screw.
- During installation make sure that the washers are fitted in the same way as they were before removal.

5. Position locking plate on steering wheel and screw down using the four fastening screws -1- and the washers. Tightening torque 4.5 ftlb.

Screwing Down Locking Plate:

Subsequent work

Subsequent work for multi-function remote control
Install driver's airbag unit.