Procedures
Removing and installing oil-level senderPreliminary work for removing oil-level sender
1. Remove intake-air distributor 1-3.
Removing oil-level sender
1. Release and disconnect cable plug-1-.
2. Unscrew two Torx screws (M6 x 20) -2- on the flange of the secondary air line -3-.
3. Carefully press flange to one side and unscrew oil-level sender with an open-ended wrench (a/f 19).
Installing oil-level sender
1. Insert oil-level sender together with a new sealing ring and tighten. Tightening torque 15 ft. lbs..
2. Position flange of secondary air line -3- together with a new seal.
3. Insert and tighten two Torx screws (M6 x 20) -2-. Tightening torque 7.5 ft. lbs..
4. Push on cable plug -1-.
Subsequent work for installing oil-level sender
1. Install intake-air distributor 1-3.