Removing and Installing Handset.

Removing And Installing Handset

Removing handset

Overview







Removing handset

1. Open lower oddments tray in the armrest.







2. Undo the four fastening screws -1- and re-close the lower oddments tray.
3. Open upper oddments tray in the armrest.







4. Remove handset and lay to one side with cable connected.







5. Unscrew the two fastening screws -2- and remove spacers.







6. Unclip telephone tray on both sides of the upper oddments tray at the four fixing clips and swivel to the rear together with the cover.







7. Unclip wire harness cover on both sides of the guide -Arrows A- and remove.
8. Remove wire harness from the guide.







9. Unscrew the three fastening screws -3- of the plug connection cover.
10. Remove plug connection cover from telephone handset cable.







11. Release plug connection -Arrow a- and disconnect.
12. Remove telephone handset.

Installing

Installing handset







1. Push the plug connection together until the locking tab -arrow- is felt to engage.







2. Fit plug connection cover on telephone handset cable.
3. Position plug connection cover and screw in the three fastening screws -3-.







4. Insert wire harness without tension into the guide.
5. Position wire harness cover and slide onto the guide until the locking tabs -arrows- are felt to engage on both sides.







6. Check fastening clips for damage and deformation, and replace if necessary.
7. Swivel telephone tray of the upper oddments tray to the front together with the cover.
8. Position telephone tray and clip in at the four fixing clips.







9. Position spacers and screw in the two fastening screws -2-.







10. Insert handset by means of the cut-out near the front into the retaining tab of the console and press down until it is felt to engage.

11. Close upper oddments tray in the armrest and open lower oddments tray in the armrest.







12. Tighten the four fastening screws -1-. Tightening torque 1.5 ftlb.
13. Close lower oddments tray.