Removing and Installing Auxiliary Brake Light
Removing And Installing Auxiliary Brake Light
Preliminary work
1. Remove top half of rear spoiler.
2. Remove ignition key.
Removing auxiliary brake light
1. Unclip the two plug connections -arrows A-.
2. Release the connector -arrow B- and disconnect it from the brake light -arrow C-.
3. Pull the washer fluid hose line off the spray nozzle -arrow D-.
NOTE: Only for vehicles with telephone
4. Unscrew the fastening screw -arrow 1-.
5. Loosen the fastening nut -2- and turn the ground strap away to the left -arrow A-.
6. Unscrew the fastening screws -arrows 3- and lay the telephone antenna aside -arrow B-.
NOTE: Only for vehicles with PCM
7. Unscrew the fastening screw -arrow 1-.
8. Loosen the fastening nut -arrow 2- and turn the ground strap away to the right -arrow A-.
9. Unscrew the fastening screws -arrows 3- and lay the GPS antenna aside -arrow B-.
10. Press out brake light to the inside -arrow A-.
11. Release the spray nozzle -arrows B- and pull it out -arrow C-.
Installing auxiliary brake light
1. Insert the spray nozzle into the additional brake light -arrow A- until the locking tabs -arrows B- click into place.
2. Position the brake light in installation position from the inside -arrow C-.
NOTE: Only for vehicles with PCM
3. Position the GPS antenna in installation position -arrow A- and screw in the fastening screws -arrows 3-, but do not tighten.
4. Move the ground strap into installation position -arrow B- and secure the ground leads with the fastening screw -arrow 1-. Then tighten the fastening nut -arrow 2- and fastening screws -arrows 3-.
NOTE: Only for vehicles with telephone
5. Place the telephone antenna in installation position -arrow A- and screw in the fastening screws -arrows 3-, but do not tighten.
6. Move the ground strap into installation position -arrow B- and secure the ground leads with the fastening screw -arrow 1-. Then tighten the fastening nut -2- and fastening screws -arrows 3-.
7. Clip in the plug connections -arrows A-.
8. Insert the connector -arrow B- until the locking tab -arrow C- clicks into place.
9. Connect the water line -arrow D-.
Subsequent work
1. Install top half of rear spoiler.