Offroad Stabilizers

Off-road Stabilizers

General instructions/safety instructions
In the following pages the 'off road stabilizer control module' is also referred to as the 'ORS control module'.

The following points must be observed during vehicle diagnosis:
- After the battery is connected, volatile memories must be reprogrammed. In the case of radio coding and tuning, the customer must be informed of decoding and the deleted tuner memory.
- After troubleshooting or repairs, erase the fault memory with the Porsche System Tester II No. 9588 and carry out a test drive.
- After the test drive, read out the fault memory with the Porsche System Tester II No. 9588 again.

DANGER:
Danger of injury through triggering of driver's airbag
- Never hang the Porsche System Tester II No. 9588 over the steering wheel.

WARNING:
- Danger of injury and damage due to unusual vehicle handling when plugs or components are disconnected.
- Never disconnect plugs when the vehicle is in motion or drive the vehicle with plugs disconnected.
- Drive only with all parts fully installed and connected.
- Danger of personal injury from moving vehicle independently with gear engaged and engine running.
- Before starting the engine in a vehicle with manual transmission, take the vehicle out of gear and put the hand-brake on firmly.
- Before starting the engine in a vehicle with automatic transmission, move the selector lever to position 'P' and put the handbrake on firmly.
- Danger of personal injury and material damage in case of incorrect use of hydraulic fluid and high fluid pressure
- Remove pressure from the hydraulic system before use.
- Refer to the corresponding regulations when handling hydraulic fluid.

CAUTION:
Danger of damage due to improper handling of batteries and control module plug connections.
- Never disconnect battery with engine running
- Never start engine if battery terminal clamps are not connected securely
- Never pull off or push on plug connections for the control modules or other electronic components when the ignition is switched on.
- Always disconnect the negative terminal of the battery and pull off all plug connections to the vehicle electrical system control module when carrying out welding work on the vehicle.