Removing and Installing Sealing Ring For Transfer Box Input Shaft
Removing and installing sealing ring for transfer box input shaftTools
Preliminary work sealing ring for input shaft transfer box
Preliminary work sealing ring for transfer box
1. Remove transfer box.
Removing sealing ring for transfer box input shaft
ATTENTION: Damage to input shaft bearing.
^ Drive bevelled attachment in by approximately 2 mm.
^ Screw sheetmetal screw max. two turns into the sealing ring.
1. Using the bevelled attachment from the slide hammer kit 168, make a small hole -figure- in the sealing ring.
2. Screw a suitable sheetmetal screw in by two turns.
3. Remove sealing ring using special tool slide hammer kit 168.
Installing sealing ring for transfer box input shaft
1. Fill the space between the dust and sealing lips on the new sealing ring with grease.
2. Drive new sealing ring in flush using special tool pressure piece t10184.
Subsequent work
Reworking sealing ring for transfer box
1. Install transfer box.
2. Check oil for transfer box.