Programming and Relearning

Teaching Hand-held Transmitter Procedure For Teaching Hand-held Transmitter

NOTE:
- The immobilizer system consists of four components - Kessy control unit/immobilizer control unit, electrical steering lock, DME control module and vehicle hand-held transmitter.
- If it is necessary to replace one of these components because of a defect, the new component can be adapted to the existing system. To do this, at least two of the components of the vehicle immobilizer system must still be present. In addition, the Porsche System Tester and the immobilizer code from IPAS are required.
- You can get the codes from IPAS or from your importer by specifying the vehicle identification number.
- Follow the instructions for the Porsche System Tester.
- Only new hand-held transmitters or those already adapted to the immobilizer system on the vehicle can be taught.
- Hand-held transmitters that have already been adapted are overwritten, and so all keys that will later be used on the vehicle must be taught.
- Teaching of keys is protected over a time period. Once this time has elapsed, teaching is aborted.

1. Ignition off. Connect the Porsche System Tester to the vehicle and start the System Tester. Select vehicle type.
2. Switch on warning indicator light; this will activate CAN and ensure that the KESSY control unit is identified.
3. Select KESSY control unit">>".
4. Select the Teaching function menu ">>".
5. Select the Teach keys menu ">>".
6. Enter immobilizer code">>" and confirm by pressing "F7".
7. Insert key 1.
8. Enter the number of keys to be taught (1 - 8), then press ">>" and confirm by pressing "F7".

Turn key No. 1 (already inserted in ignition lock) to position ON (ignition) - ignition is switched on if teaching is correct.

NOTE: In the case of keys with the Keyless function, after teaching, press a button on the radio remote control to activate this function.

Turn key No. 1 to OFF and remove from ignition lock.

Insert key No. 2 in ignition lock and turn to position ON (ignition), then press ">>" - ignition is switched on if teaching is correct.

Repeat procedure with all keys to be taught (having entered number).

9. Read out and erase fault memory.
10. Start the engine with all the taught keys/hand-held transmitters in turn.