Removing and Installing Dashboard Cover on the Driver's Side

Removing And Installing Dashboard Cover On The Driver's Side

Tools







Tools and materials

Keys T10152

Removing dashboard cover on the driver's side







1. Remove trim strips for the dashboard on the driver's side. Refer to Removing and installing dashboard moulding on driver's side
2. Remove trim panel under dashboard on the driver's side. Refer to Removing and installing trim panel under dashboard.
3. Remove air vent for door window. Refer to Removing and installing air vent for door window.






4. Remove ignition switch. To do this, unscrew the union nut -1- using the appropriate special tool -arrow A- and remove it -arrow B-.






5. Push the ignition switch -2- through to the inside -arrow C-.




6. Remove top section of the steering column trim. To do this, adjust the steering column downward and to the rear.









7. Disengage the holding straps -3- on the top section of the steering column trim -4- using a screwdriver. To do this, the steering wheel must be turned 90 degrees from the middle position to the left and then 180 degrees to the right.







8. Lift the top section of the steering column trim -4- at the rear -arrow D- and pull it out of the holding straps -arrow E-.







9. Remove instrument panel cover on the driver's side. To do this, unscrew the fastening screw -5-.







10. Remove the cover for the instrument panel on the driver's side -6- to the rear together with the top section of the steering column trim -arrow F-.




Installing dashboard cover on the driver's side










1. Insert the cover for the instrument panel on the driver's side -6- together with the top section of the steering column trim -arrow A-.







2. Screw in fastening screw -5-.






3. Install top section of steering column trim. To do this, insert top section of steering column trim -4- into the holding strap at the front.













4. Push top section of the steering column trim -4- down at the rear -arrow C- until the holding straps -3- engage audibly.

5. Adjust the steering column forward and upward.






6. Install ignition switch. To do this, push the ignition switch -2- from the rear through to the front -arrow D-.







7. Put on union nut -1- -arrow E- and screw it in using the appropriate special tool -arrow F-.
8. Install air vent for door window. Refer to Removing and installing air vent for door window.
9. Install trim panel under dashboard on the driver's side. Refer to Removing and installing trim panel under dashboard.
10. Install dashboard moulding on the driver's side.