Oil Pump: Service and Repair

Removing and installing oil pump
Information
Component overview

Component Overview Of Oil Pressure Control Valve:

Preliminary work

Remove oil pan.

Removing oil pump

To remove the oil pump, the engine must be removed or supported on the body so that the engine carrier can be removed.

Fastening Screws:

ATTENTION: Danger of injury due to oil pump drive shaft falling out!
^ The drive shaft will fall out when the oil pump is removed.
--> Secure and carefully remove the shaft by hand when working over your head.

1. Loosen the 2 fastening screws -1- on the oil pipe. Then loosen the 2 fastening screws -2- on the oil pump. Remove pump.

Drive Shaft:

2. Remove drive shaft.

Installing oil pump


Note: Seals must always be replaced.





1. Insert drive shaft for oil pump into the cylinder block. When doing so, make sure that the two plastic washers are in place.
2. Fit new seal under the intake manifold.

Fastening Screws:

3. Position oil pump on cylinder block and screw in the 2 fastening screws -2-. Then fit a new seal under the oil tube. Insert the fastening screws -1- with screw locking agent and tighten. Tightening torque 6 ft. lbs. Then tighten the fastening screws of the oil pump. Tightening torque 17 ft. lbs.

Subsequent work

Install oil pan.