General Information on the Fault Memory
AWSGeneral information on the fault memory
NOTE:
- A period of 10 seconds is required to enable the triggering unit to identify all faults in the system. To ensure that every possible fault source is checked during the vehicle test, the ignition must be switched on for at least 10 seconds.
- The fault memory must be erased after a fault is detected and remedied in the AWS system.
- The replacement of a component must be noted in the Guarantee and Maintenance booklet. To do this, attach the documentation number in a free panel intended for that purpose. The documentation number is attached to the replacement part as a tear-off sticker.
NOTE: If the fault memory is erased, a reset must be performed in order to check the fault path (the ignition must be switched off, the ignition key removed for 30 seconds and the ignition must then be switched on again). Only in this way is another self-test carried out.
NOTE: The AWS must be re-calibrated following an accident in which the airbag system was triggered and was subsequently repaired.