Removing and Installing Countershaft Cap
Removing and installing countershaft capTools
Preliminary work for countershaft cap
1. Remove transmission.
Removing countershaft cap
Overview of cap
1. Drive two small holes -figure- - offset by 180° - into the sealing ring. Preparatory work for
removing sealing ring
2. Screw two sheet metal screws into the holes in the cap.
Screwing in sheet metal screws
3. Remove cap using slide hammer kit nr.168.
Removing sealing ring
Installing countershaft cap
Overview of cap
1. Drive new cap in flush using special tool pressure piece t10180.
Reworking countershaft cap
1. Install transmission.
2. Check transmission oil.