Replacing Bulb For Engine Compartment Light

Replacing Bulb For Engine Compartment Light

Removing bulb for engine compartment light

Removing engine compartment light

CAUTION:
Danger of damage to property if bulbs are used or handled incorrectly.
- Risk of damage to bulbs and bulb housing.
- Switch off ignition and remove ignition key.
- To prevent short circuits, the load in question must be switched off while changing bulbs.
- Only bulbs specified in the bulb table may be used.
- Bulbs with a higher wattage may damage the bulb housing.
- New bulbs must be clean and free of grease. Therefore, never touch the bulbs with your bare hands. Use a cloth or soft paper when changing bulbs.
- In certain states, it is compulsory to carry spare light bulbs.












1. Disengage wiring harness on blower motor housing.







2. Press engine compartment light carefully out of the blower motor housing at the cutout -arrow- using a screwdriver.
3. Pull off plug on engine compartment light and remove engine compartment light.

Removing bulb for light







1. Remove defective bulb from between the contact springs.

Installing bulb for engine compartment light

Installing bulb for light

INFORMATION: Only use the relevant bulb specified in the bulb table.







1. Insert new bulb into the contact springs.

Installing engine compartment light












1. Attach plug on engine compartment light.
2. Press engine compartment light into the blower motor housing.







3. Engage wiring harness on blower motor housing.