Removing and Installing Multi-Function Remote Control

916119 Removing And Installing Multi-function Remote Control

Preliminary work

Preliminary work for multi-function remote control
Remove driver's airbag unit.

Removing multi-function remote control

Installation position of steering wheel, shown on the 911:

NOTE:
- When removing the locking plate, take note of how many washers are used on each fastening screw.
- During installation make sure that the washers are fitted in the same way as they were before removal.

Removing the locking plate:

1. Unscrew the four fastening screws -1- on the locking plate in the steering wheel and remove along with the locking plate.

Removing multi-function control unit:

2. Use a screwdriver to carefully lever the multi-function control unit out of the steering wheel.

Releasing electric plug connection:

3. Release electric plug connection -A- and disconnect it from the multi-function control unit.

Removing remote control from steering wheel:

4. Unscrew the fastening screws -2- and washers -3- for the remote control and carefully lever the remote control out using a screwdriver.

Releasing plug connection on the remote control:

5. Release the electric plug connection on the remote control -A- and disconnect it.
6. Remove remote control.

Installing multi-function remote control

Connecting plug connection on the remote control:

1. Insert electric connector into the remote control until it clicks into place. Connecting plug connection on the remote control
2. Insert remote control into the steering wheel, position washers -3- and screw down with the fastening screw -2-.
3. Attach electric plug connection to multi-function control unit until the plug clicks into place.

Clipping multi-function control unit into steering wheel:

4. Clip multi-function control unit into steering wheel. Check that it is secure.

NOTE:
- When removing the locking plate, take note of how many washers are used on each fastening screw.
- During installation make sure that the washers are fitted in the same way as they were before removal.

Screwing down locking plate:

5. Position locking plate on steering wheel and screw down using the four fastening screws -1- and the washers. Tightening torque 4.5 ftlb.

Subsequent work

Subsequent work for multi-function remote control
Install driver's airbag unit.