Removing and Installing the Rear Retaining Strip

635719 Removing And Installing The Rear Retaining Strip

Tools







Preliminary work
Remove rear apron.

Tools and materials

Producing assembly fixture

NOTE: The following assembly fixtures must be produced for assembly work on the rear retaining strip.

1. The following tools and materials are required for producing the assembly fixtures:
1.2. Sabre saw 00000
1.2. Measuring tape 00000
1.3. Commercially available hardwood block 00000
2. Produce hardwood block, assembly fixtures -A- with corresponding dimension specifications 120 x 72 x 72 mm.

Dimensions For Assembly Fixture:

Removing the rear retaining strip

Installation Location Of Rear Retaining Strip:

1. Unclipping wiring harness for rear apron
2. Unscrew fastening nuts -1- and take off rear retaining strip -2-. Check sheetmetal nuts -3-, replace if necessary.

Removing The Rear Retaining Strip:

Installing the rear retaining strip

Installation Location Of Rear Retaining Strip:

1. Position rear retaining strip -2- with fastening nut attached -3-.

Installing The Rear Retaining Strip:

2. Position fastening nuts -1- carefully.
3. Adjust the rear retaining strip.
4. Tighten fastening nuts -1-.
Tightening torque 7 ftlb.
5. Clip in wiring harness for rear apron.

Additional assembly instructions for installing rear retaining strip

Function dimensions for rear retaining strip

Installation Location Of Rear Retaining Strip:

NOTE: However, the precondition for precise positioning of the retaining strip is that the rear lid is optimally adjusted and correctly locked in the lock in accordance with the joining plan and the functional dimensions, before the rear retaining strip is assembled.

1. Check the function dimensions for the rear lid, and correct if necessary.
2. Move in assembly fixtures -1- at the measuring point -A = 276 mm- between the retaining strip -2- and rear lid -3-.

Adjusting The Retaining Strip:

NOTE: Ensure that the distance from the retaining strip to the side panel is uniform on the right and the left.

3. Push retaining strip -2- upwards and screw down the two fastening nuts -4-.
Tightening torque 7 ftlb.

Subsequent work
Install rear apron.