Antenna: Testing and Inspection

Checking Antenna Leads

Tools







Closed-circuit current should be measured using an analog or digital multimeter with a long integration time (to filter out voltage peaks).

General Checks
1. Comparison checking
a. Check how many radio transmitters are received. To do this, compare the transmitters received using another vehicle since the reception can vary considerably, depending on the area.

2. Visual inspection
a. Remove upper part of rear spoiler.

NOTE: The antenna plugs and antenna leads are not available individually. If the antenna plugs or antenna leads are damaged at the disconnection point on the roof, the complete wiring harness must be replaced.

b. Check that antenna leads are not crushed or severely kinked. Replace damaged antenna lead and corresponding wiring harness if necessary.
c. Check antenna plugs for visible damage. Replace wiring harness with damaged plug if necessary.
d. Check that all plug connections are inserted and locked correctly.
e. Check that the correct components are installed.

Radio CDR23

Work Instruction 1 - 2:

Work Instruction 3 - 7:

Work Instruction 8:

PCM

Work Instruction 1 - 3:

Work Instruction 4 - 8: