Removing and Installing Receiver For the Digital Radio

Removing And Installing Receiver For The Digital Radio

Tools







Removing the receiver for the digital radio

Loosening the receiver holder for the digital radio







ATTENTION:
Risk of destruction when removing electric components with the ignition on.
- Switch off ignition and remove ignition key.

1. Switch off ignition and remove ignition key.
2. Fold forward 2/3 rear seat.
3. Unscrew both fastening screws -1- and swivel the receiver holder for the digital radio to the rear.







Unplugging the plug on the receiver for the digital radio







1. Unlock the three plugs on the receiver for the digital radio -arrows a- and unplug.







Removing the receiver for the digital radio







1. Push both locks on the receiver holder for the digital radio downward -arrows A-.







2. Push out receiver for the digital radio out of the four tabs -arrows--arrows B- and remove.

Installing the receiver for the digital radio
1. Insert receiver for the digital radio in the receiver holder and push into the four tabs -arrows--arrow A- until both locks -arrows B- are felt to engage.-{}-







Connecting the plug on the receiver for the digital radio
1. Connect the three plugs on the receiver for the digital radio until the plugs are felt to engage.







Fastening the receiver holder for the digital radio
1. Swivel the receiver holder for the digital radio to the front and screw down with both fastening screws -1-. Tightening torque Final puller: 4.5 ftlb.







Performing a reception test

NOTE:
- If the receiver for the digital radio is replaced, a reception test must be performed with the PIWIS tester.
- During the reception test, it is essential to guarantee the power supply for the PIWIS tester. It is essential to connect a battery charger with a current rating of at least 40 A to the vehicle battery.
- The PIWIS tester instructions take precedence and in the event of a discrepancy these are the instructions that must be followed. Deviations may occur with later software versions.
- The procedure described here has been structured in general terms; different text or additions may appear in the PIWIS tester.

1. Connect the PIWIS tester 9718 to the vehicle and start it. Switch on the ignition. .>>" Continue.
2. Select vehicle type and continue with .>>".
3. Select the PCM2 control module and continue with .>>".
4. Select Satellite radio and continue with .>>".
5. Select Special function and continue with .>>".
6. Select Reception test and continue with .>>".
7. Follow the instructions on the PIWIS tester.
8. Read out the fault memory and, if necessary, erase it.