Headlamp Bulb: Service and Repair

Removing And Installing Halogen Bulb

Preliminary work
1. Remove main headlight.
2. Observe bulb table and installation instructions.

Removing halogen bulb

Removing dipped beam halogen bulb

WARNING:
Risk of short circuit.
- Before removing the headlight, remove ignition key and switch off light switch.

NOTE: Observe instructions.

1. Open the two locking bars -1- on the headlight and remove cover-2-.







2. Pull off connector -3- and disengage securing clip -4-.







3. Remove halogen bulb -5- from housing.







Removing high beam halogen bulb

NOTE: Observe instructions.

1. Open the two locking bars -1- on the headlight and remove cover -2-.







2. Disengage securing clip.







3. Pull off connector and remove halogen bulb from housing.







Removing auxiliary high beam halogen bulb

NOTE: Observe instructions.

1. Remove cover -2-.







2. Pull connector -5- off the lamp -4-.







3. Disengage securing clip -3- and remove lamp.

Removing cornering light halogen bulb

NOTE: Observe instructions.

1. Open the two locking bars -1- on the headlight and remove cover -2-.







2. Disengage securing clip.







3. Remove lamp from housing and pull off electric lead.







Installing halogen bulb

Installing dipped beam halogen bulb

NOTE: Observe instructions.

1. Insert halogen bulb -5- into the bulb housing. Pay attention to the installation position.







2. Engage securing clip -4- and insert connector -3-.







3. Place cap -2- in position, press it down and close locking bar -1-.







Installing high beam halogen bulb

NOTE: Observe instructions.

1. Attach connector and insert halogen bulb into the bulb housing.







2. Engage securing clip.







3. Place cap -2- in position, press it down and close locking bar -1-.







Installing auxiliary high beam halogen bulb

NOTE: Observe instructions.

1. Insert halogen bulb -4- into bulb housing and engage securing clip -3-.







2. Connect connector -5- to halogen bulb -4-.
3. Fit cover -2- and make sure it is seated securely. Do not use sliding agents/lubricants.







Installing cornering light halogen bulb

NOTE: Observe instructions.

1. Insert lamp into headlight housing and connect electric lead.







2. Engage securing clip. Ensure bulb is seated properly.







3. Place cap -2- in position, press it down and close locking bar -1-.







Subsequent work
1. Install main headlight and perform function test.