Offroad Stabilizers
Fault Code 0456
KESSY control module (CAN drive)
Diagnostic conditions
- Ignition on
- Internal off road stabilizer control module function test
Possible causes of fault
- No signal/communication (no signal from KESSY control module on CAN drive)
Affected pins
Off-road stabilizer control module connector B:
- Pin 1 'CAN drive (high)'
- Pin 3 'CAN drive (low)'
Diagnosis/troubleshooting
NOTE: If there is no incoming signal via the CAN drive using several control modules, the CAN drive must be checked for open or short circuits. Refer to 'Checking instructions/CAN data bus'.