Fault Code 1166
Fault Code 1166/P2637
Engine torque signal [Torque Management Feedback Signal "A"]
Diagnostic conditions
- Ignition on
- Internal Tiptronic control module function test
- Engine running
Possible cause of fault
- Signal from DME control module does not correspond to expected signal (please read out fault memory)
- Signal from DME control module does not appear on CAN drive (no signal/communication)
Affected pins
Tiptronic control module plug:
- Pin 34 CAN drive (low)
- Pin 46 CAN drive (high)
Diagnosis/troubleshooting G 0210
NOTE: If there is no incoming signal via the CAN drive using several control modules, the CAN drive must be checked for open or short circuits. Refer to Checking instructions/CAN data bus.