Operation CHARM: Car repair manuals for everyone.

Tiptronic



Fault Code 1314/P0614/P0864

DME control unit [ECM/TCM Incompatible/TCM Communication Circuit Range/Performance]

Diagnostic conditions
- Ignition on
- Internal control unit function test

Possible causes of fault

NOTE: The Tiptronic control unit is coded in the DME control unit.

DME control unit was replaced and coded incorrectly or was not coded (no or incorrect basic setting/adaptation)

- Engine type coded incorrectly (no or incorrect basic setting/adaptation)
- Transmission type coded incorrectly (no or incorrect basic setting/adaptation)
- To localise the fault, read out the fault memory for the DME control unit (Please read out fault memory)
- No message from DME control unit on CAN drive (no signal/communication)

Affected pins
Tiptronic control unit plug:
- Pin 34 CAN drive (low)
- Pin 46 CAN drive (high)

Diagnosis/troubleshooting G 0210

NOTE: If there is no incoming signal/message via the CAN drive using several control units, the CAN drive must be checked for open or short circuits. Refer to Checking instructions/CAN data bus.


Work Instruction 1 - 3: