Removing and Installing Receiver For the Digital Radio

Removing And Installing Receiver For The Digital Radio

Tools







Technical values







Removing the receiver for the digital radio

Loosening the receiver holder for the digital radio







CAUTION:
Risk of short circuit.
- Before removing the control unit, switch off the ignition.

1. Switch off ignition and remove ignition key.
2. Fold forward 2/3 rear seat.







3. Unscrew the two fastening screws -1- and swivel the support of the receiver for the digital radio to the rear -arrow-.

Unplugging the plug on the receiver for the digital radio







1. Release connector on receiver for digital radio -arrows a- and pull off -arrows-.

Removing the receiver for the digital radio
1. Remove receiver for the digital radio.
1.1. Press the two locking mechanisms on the support of the receiver for the digital radio downwards -arrows A-.







1.2. Press out receiver for digital radio over the four retaining lugs -arrows- (-arrow B-) and remove.

Installing the receiver for the digital radio







1. Push receiver for the digital radio over the four retaining lugs -arrows- into the support of the receiver for the digital radio -arrow A- until the two locking mechanisms -arrows B- engage securely.

Connecting the plug on the receiver for the digital radio







1. Connect the three connectors on the receiver for the digital radio -arrows- until the connectors engage securely.

Fastening the receiver holder for the digital radio







1. Swivel support of receiver for digital radio forwards -arrow- and screw down with the two fastening screws -1-. - Tightening torque: 6 Nm (4.5 ftlb.)

Performing a reception test

INFORMATION:
- If the receiver for the digital radio is replaced, a reception test must be performed with the PIWIS tester.
- During the reception test, it is essential to guarantee the power supply for the PIWIS tester. It is essential to connect a battery charger with a current rating of at least 40 A to the vehicle battery.
- The PIWIS tester instructions take precedence and in the event of a discrepancy these are the instructions that must be followed. Deviations may occur with later software versions.
- The procedure described here has been structured in general terms; different text or additions may appear in the PIWIS tester.

1. Connect the PIWIS tester 9718 to the vehicle and start it. Switch on the ignition. >> Continue.
2. Select vehicle type and continue with >>.
3. Select the PCM2 control module and continue with >>.
4. Select Satellite radio and continue with >>.
5. Select Special function and continue with >>.
6. Select Reception test and continue with >>.
7. Follow the instructions on the PIWIS tester.
8. Read out the fault memory and, if necessary, erase it.