Engine Mounting

WM 103519 Removing and installing engine mounting





Preliminary work

Preliminary work

1. Support engine on the body.
2. Remove engine guard.
3. Remove front axle until the engine carrier can be removed.

Information

Component overview





Component overview

1 - Fastening nut, M12 X 1.5
2 - Bracket for auxiliary units
3 - Fastening screw, M10 x 45
4 - Align left-hand hydraulic mount with the aid of the engine carrier -5- then tighten the fastening nuts -1-.
5 - Engine carrier
6 - Fastening screw
7 - Align right-hand hydraulic mount with the aid of the engine carrier -5- then tighten the fastening nuts -1-.
8 - Engine carrier, right
9 - Fastening screw, M10 x 45

Removing engine mounting

Removing engine mounting

Warning:
Danger of injury!

- When working on the engine suspension, the engine must be appropriately secured against falling or lowering.

- Never use defective lifting equipment.

- Only use lifting equipment tested and approved by Porsche.

- The components are very heavy. There is a danger of crushing.

- Wear protective gloves.

- Please observe general warning notes.

Information:
This task can only be performed in the Cayenne S (M48/00) if the engine has been removed or suspended on the body. This description covers suspension on the body.
The engine must be removed on the Cayenne Turbo (M48/50). The turbochargers are removed next.

1. Undo the two fastening screws -Arrows- to the left and right on the hydraulic mounts.





Hydraulic mount

2. Undo the two fastening screws from the engine carrier to the body and remove the engine carrier. -Center arrow-





Engine carrier

3. Undo engine mounts. To do this, undo the fastening nuts on the support arms and remove the engine mounts.

Installing engine mounting

Installing engine mounts

Information:
The engine mounts must be aligned using the engine carrier.
The engine mounts differ (left/right) and must not be interchanged.

1. Position engine mounts on the support arm. When doing so, note the positioning pin on the mount. It must engage in the recess on the support arm.
2. Position new fastening nuts and screw them on so that the positioning pin cannot pop out. Do not tighten the fastening nuts.
3. Fit the engine carrier. Position the fastening screws (M10 x 45) for the hydraulic mounts and tighten them. - Tightening torque: 44 ftlb.





Fastening screws for hydraulic mount

4. Tighten engine mounts on the engine. Tighten the fastening nuts. - Tightening torque : 56 ftlb.

Subsequent work

Subsequent work

1. Screw in new fastening screws for securing the engine carrier to the body. - Initial tightening: 89 ftlb. - Torque angle: 180°
2. Install front axle.
3. Install engine guard.