Tightening Torques

WM 1001IN Tightening torques for Cayenne S (M48/00) and Cayenne Turbo (M48/50)

Information

Information





V8 engine

Information:
This torque list is organized according to component groups in the same way as service numbering.
The torque for the coolant pump is provided in Chapter 19.
The tightening sequences are indicated in the figures in the corresponding chapters, and it is essential to observe them.
The most important torques are specified at the end of the respective chapters.

The torques in the table below generally apply to screws which are not specifically listed.








Tightening sequences

















Tightening sequences

Information:
The exterior fastening screws must have a quality of 10.9.
If the quality is 8.8, the screws must be replaced.
Tighten screws 1 to 4 (M6 / 8.8) to 7.5 ftlb.
Tighten screws 5 to 6 (M8 / 8.8) to 17 ftlb.
Tighten screws 7 to 32 (M6/10.9) to 13 Nm (9.5 ftlb.).




















Tightening sequences





Thermostat housing





Water pump











Tightening sequences





Suction module





Tightening sequences





Exhaust manifold








Cylinder Head Re-Usability
Fit cylinder head. Insert M12 x 1.5 x 140 cylinder head screws (screws can be used again).

Drive Plate
Tighten the ten new fastening screws crosswise.
Tightening torque: 44 ftlb. then Torque angle: 90�
(Always replace screws with new ones!)