Refrigerant Pressure Sensor / Switch: Service and Repair

Removing And Installing Pressure Switch

Technical Values







Preliminary work
1. Remove wiper linkage.
2. Remove cowl panel cover.

Removing pressure switch

INFORMATION: The pressure switch is located in the radiator tank in the direction of travel under the cowl panel cover.







CAUTION:
Danger of injury from contact with the refrigerant
- Observe safety regulations when working with refrigerant.

1. Drain refrigerant.







2. Press release on electrical connector -a- and disconnect from pressure switch.







3. Place one open-ended wrench on the hexagon of the pressure switch and a second open-ended wrench on the hexagon of the refrigerant line.
4. Unscrew pressure switch from refrigerant line in direction of arrow and remove.

Installing pressure switch
1. Replace the O-ring on the pressure switch and wet it with refrigerant oil.







2. Screw pressure switch onto refrigerant line and tighten with an open-ended wrench. Counter with a second open-ended wrench. - Tightening torque: 3.5 ftlb.







3. Push electrical plug onto pressure switch until it clicks into place.

Subsequent work
1. Fill in refrigerant.
2. Install cowl panel cover.
3. Install wiper linkage.