Removing and Installing Padding For 1/3-Split Folding Rear Backrest

Removing And Installing Padding For 1/3 - Split Folding Rear Backrest

Technical values







Removing padding for 1/3-split folding rear backrest










1. Remove backrest. Refer to Removing and installing rear backrest.
2. Remove locking mechanism for rear backrest. Refer to Removing and installing locking mechanism for rear backrest.
3. Removing headrest
4. Remove support: Undo fastening screws -2-.







5. Remove the support -1- -Arrow A-.







6. Removing headrest guides: Insert screwdriver (width 2 mm) from inside into bore above locking tab.
7. Press screwdriver in direction of arrow -Arrow B- and release locking tab -Arrow C-.







8. Pull out headrest guides -3- -Arrow D-.







9. Remove padding for backrest: Lever out piping -4- of cover for seat -5- with a plastic wedge at the upper left corner -Arrow E-.







10. Pull piping -4- of cover for backrest -5- out completely in the direction of the arrow.







11. Pull cover for backrest -5- over the pin -6- -Arrow F-.







12. Pull cover for backrest -5- over the holder for child-lock button -7- -Arrow G-.







13. Remove backrest frame -8- from the padding with cover for backrest -5- -Arrow H-.







14. Remove cover for rear backrest. Refer to Removing and installing cover for rear backrest.

Installing padding for 1/3-split folding rear backrest










1. Install cover for rear backrest. Refer to Removing and installing cover for rear backrest.
2. Place backrest frame -8- on the padding with cover for backrest -5- and align -Arrow A-. In doing so, pull cover for backrest -5- over the holder for child-lock button -7- -Arrow C-.










3. Pull cover for backrest -5- over the pin -6- -Arrow D-.







4. Press piping -4- of cover for backrest -5- completely into the backrest frame in direction of arrow -8- -Arrow B-.










INFORMATION: The headrest guide with the headrest release is installed at the left side; the locking tabs of both headrest guides are facing inwards.

5. Installing headrest guides: Press in headrest guides -3- -Arrows E-, until the locking tabs engage audibly.







6. Install support: Position the support -1- -Arrow F-.







7. Screw in fastening screws -2- and tighten to the specified torque. Refer to Removing and installing locking mechanism for rear backrest.







8. Install locking mechanism for rear backrest. Refer to Removing and installing rear backrest.
9. Install backrest. Refer to Removing and installing rear backrest.