Rear Seat

Removing And Installing Back Seat

Technical values







Removing back seat







1. Unlock rear seats -1, 2- and fold up 90 degrees.







2. Only in vehicles with seat heater:
Release plug -Arrow A- and pull it off -Arrow B-.







3. Unclip the connector -Arrow C-.







4. Unscrew fastening screws -3-, -3- and -3-.













5. Remove rear seats, see figure.







Installing back seat







CAUTION: Danger of material damage to seat bolts.
- The fastening screws for seats are coated and must be replaced after being unscrewed.
- Before screwing in the new fastening screws, clean the thread holes with an M 10 tap.

1. To position the rear seats, unfold hinge parts on the rear seats and place seats in a raised position, see figure.







2. Screw in fastening screws -3-, -3- and -3- and tighten to the specified tightening torque. Tightening torque: 50 Nm (37 ftlb.)+10 Nm (+7.5 ftlb.)













3. Only for vehicles with seat heater: Clip in plug -Arrow A-.







4. Push on the connector -Arrow B- until the locking tabs engage audibly -arrows-.







5. Fold down rear seats -1, 2- and lock them.