Belt Tensioner
Removing and installing belt tensionerPreliminary work
1. Loosen drive belt around the belt tensioner.
Information
Component overview
Removing belt tensioner
1. Loosen the bottom fastening screw on the shock absorber.
2. Loosen the top fastening screw.
3. Remove components and repair appropriate components.
4. In order to remove the tensioning roller -figure shows deflector roller, the cap must be levered off first. To do this, insert a small screwdriver underneath the cap and lever it off.
Installing belt tensioner
Note:
^ When fitting the shock absorber/tensioning element, ensure that the label can be read from outside.
^ The bellows must be facing upwards.
1. Install holder with tensioning element. Tighten the top fastening screw. Tightening torque: 24 ft-lb.
2. Tighten the bottom fastening screw. Tightening torque: 24 ft-lb.
Subsequent work
1. Fit drive belt.