Removing and Installing Multi-Functional Switch 2WD
Removing and installing multi-functional switchPreliminary work for multi-functional switch
1. Remove engine guard.
Removing multi-functional switch
Overview Of Multifunctional Switch:
1. Move selector lever to position N.
2. Remove shield on the transmission. To do this, unscrew three fastening screws -arrow-.
3. Pull off cable on multi-functional switch.
4. Remove cap nut, cap, nut with tab washer and rubber washer on the multi-functional switch.
5. Unscrew fastening screws on the multi-functional switch -arrow-and remove switch.
Installing multi-functional switch
Overview Of Multi-functional Switch:
1. Put multi-functional switch on the selector shaft.
2. Adjust multi-functional switch.
3. Position cable on multi-functional switch.
4. Install shield on the transmission. To do this, screw in three fastening screws -arrow-. Tightening torque: 7.5 ftlb.
5. Functional test of gear selecting system:
^ Will the vehicle start?
^ Do all the selector lever positions work?
Subsequent work
Reworking multi-function switch
1. Fit engine guard.