Removing and Installing Footwell Light

Removing And Installing Footwell Light

Removing footwell light

CAUTION:
Danger of damage to property if bulbs are used or handled incorrectly.
- Risk of damage to bulbs and bulb housing.

- Switch off ignition and remove ignition key.
- To prevent short circuits, the load in question must be switched off while changing bulbs.
- Only bulbs specified in the bulb table may be used.
- Bulbs with a higher wattage may damage the bulb housing.
- New bulbs must be clean and free of grease. Therefore, never touch the bulbs with your bare hands. Use a cloth or soft paper when changing bulbs.
- In certain states, it is compulsory to carry spare light bulbs.












1. Press footwell light carefully out of the trim panel at the cutout -arrow- using a screwdriver.
2. Release plug on footwell light -arrows a- and pull it off.
3. Remove footwell light.

Installing footwell light

INFORMATION: Only use the relevant bulb specified in the bulb table IN - Bulb table and installation instructions - "Information" chapter.












1. Push plug on to footwell light until the plug is felt to engage.
2. Press footwell light into trim panel.