Removing and Installing Cover For Rear Underbody

Removing And Installing Cover For Rear Underbody

Technical values







Preliminary work

Raise the vehicle. Refer to Lifting the vehicle

Removing cover for rear underbody

Removing cover for rear underbody - rear section







1. Unscrew fastening screws -2-.







2. Remove rear underbody cover -1-.

Removing cover for underbody - front section







INFORMATION: Fastening nuts cannot be used again following removal.

1. Unscrew fastening screws -2- and fastening nuts -3-.







2. Pull cover for underbody -4- out of the two brake air ducts -5- at the rear and remove it.
3. Unscrew fastening screw -2- and remove brake air duct -5-.







Installing cover for rear underbody

Installing cover for rear underbody - front section







INFORMATION: When sliding in the underbody cover, make sure the overlap is correct.

1. Position brake air duct -5- on the transverse strut and secure with the fastening screw -2-. Tightening torque: 2 Nm (1.5 ftlb.)







2. Insert cover for underbody -4- and engage it at the two brake air ducts -5- at the rear.







3. Tighten fastening screws -2-. Tightening torque: 2 Nm (1.5 ftlb.)

INFORMATION: Fastening nuts cannot be used again following removal.

4. Tighten fastening nuts -3-. Tightening torque: 2.5 Nm (2.0 ftlb.)

Installing cover for rear underbody - rear section







INFORMATION: When sliding in the underbody cover, make sure the overlap is correct.

1. Insert cover for rear underbody -1-.







2. Tighten fastening screws -2-. Tightening torque: 2 Nm (1.5 ftlb.)

Subsequent work

Reworking

Lower the vehicle. Refer to Lifting the vehicle.