661719 Removing and installing moulding for wing

WM 661719 Removing and installing moulding for wing

Removing moulding for wing

Information

- The moulding is destroyed during removal.

1. Heat up moulding with a hot-air gun to approx. 60°C.
2. Open door.
3. Using an assembly wedge, traverse between moulding and cover and lift off the moulding.





4. Remove moulding completely, reheating if necessary.
5. Close the door.
6. To protect from damage, mask painted surfaces along the top and bottom edges.
7. Warm up adhesive tape residue off the cover and scrape off with an assembly wedge.

Installing moulding for wing

Information

Only cleaning alcohol (isopropanol) may be used for cleaning. Other cleaning solutions can damage the plastic.

1. Wipe the bonding areas on the cover and reverse side of the moulding with cleaning alcohol.





2. Pull off strips of adhesive tape to protect paintwork.
3. Stick a strip of adhesive tape along the upper and lower edge of the sealing surface.





4. Remove protective film from the adhesive strip.
5. Position moulding and lay it on the adhesive strip.





6. Warm up moulding with a hot-air gun and press down evenly on the cover.