946419 Removing and Installing Fog Lights
WM 946419 Removing and installing fog lights
Technical values
Preliminary work
1. Release wheel housing liner in the front area. => 505619 Removing and installing front wheel housing liner - section on "Removing"
Removing fog lights
Removing support with fog light
Installation position of fog light
CAUTION
Risk of short circuit.
-> Before removing the headlight, remove ignition key and switch off light switch.
1. Release connector -1- ( -arrow A- ) and pull off from fog light -2- ( -arrow B- ).
Pulling off connector from fog light
2. Remove support with fog light.
2.1. Pull water hose -3- out of the retaining clip -arrow A-.
2.2. Unscrew fastening screws -1- and remove support with fog light -2- ( -arrow B- ).
Removing support with fog light
Removing fog lights
1. Remove fog light.
1.1. Unscrew fastening screws -1-.
1.2. Lift fog light -2- on the left side -arrow A- and remove from the support -arrow B-
Removing fog light
Installing fog lights
1. Install fog light.
1.1. Position fog light -2- in the support -arrow A- and insert fully -arrow B-.
1.2. Secure fog light -2- with the fastening screws -1-. => Tightening torque: 3 Nm (2.0 ftlb.)
Installing fog light
Installing support with fog light
1. Install support with fog light
1.1. Insert support with fog light -2- with the guide into the front apron -arrow A-.
1.2. Secure support with fog light -2- using the fastening screws -1-. => Tightening torque: 3 Nm (2.0 ftlb.)
1.3. Press water hose -3- into the retaining clip -arrow B-.
Installing support with fog light
2. Push connector -1- onto the fog light -2- ( -arrow- ) until the connector engages securely.
Pushing connector onto fog light
Setting the fog lights
1. Using a hexagon socket screwdriver through the opening -1- in the front apron, set the fog light -arrow A- or -arrow B-.
Setting the fog light
Subsequent work
1. Secure wheel housing liner in the front area. => 505619 Removing and installing front wheel housing liner - section on "Installing"