P1026

P1026

Diagnosis information - DME V8 DFI

Fuel high pressure implausible

NOTE:
- Faults in the fuel high-pressure injection area are often caused by defects in the predelivery circuit (fuel low-pressure).
- Therefore, if there are problems in the fuel high-pressure injection area, the predelivery circuit must be checked first.

NOTE: The fault type >Upper limit value exceeded [or] Lower limit value not reached< does not necessarily have any significance.

NOTE: It is possible to read out in the extended fault memory whether the fault entry has been caused by the value exceeding or not reaching the respective limit:

- refer to the fault memory under
--> >[F8] [i]<
--> >[F5] ENVIRONMENTAL CONDITIONS<
--> >Environmental conditions when fault first occurred<
--> Environment 6 (last value) is the fuel high pressure when the fault occurred:
- Value < 10 bar means that the pressure was below the limit
- Value > 135 bar means that the limit was exceeded

NOTE:
CONVERSION:
- 10,000 hPa = 10 bar = 10,000 mbar
- 1,000 kPa = 10 bar = 10,000 mbar
- 1 MPa = 10 bar = 10,000 mbar

Diagnostic conditions
- Battery positive voltage > 9 V
- Engine start recognized > 5 sec.
- Engine temperature - 10 °C ...+ 100 °C (50 °F ... 212 °F)
- Engine running (driving)

Fault setting conditions
- Continuous average fuel high pressure < 10 bar
or
- Continuous average fuel high pressure > 135 bar

Possible fault causes
- Only if the value is below the lower limit:
- Predelivery quantity or pressure in fuel low-pressure circuit too low
- Tank (almost) (driven) empty
- refer to the fault memory under
--> >[F8] [i]<
--> >[F8] EXTENDED FAULT MEMORY<
--> Value >Fuel Level Input<
--> The value is then [0%]

- If the value is below or exceeds the limits:
- Quantity control valve faulty (in fuel high-pressure pump)
- Fuel high-pressure pump faulty