Antitheft and Alarm Systems: Service and Repair

Removing And Installing Sensor For Passenger Compartment Monitoring

Removing sensor for passenger compartment monitoring
1. Remove ignition key.







2. Remove cover for interior light. From side of windscreen, grasp centre of bulb cover and pull down. Unclip light unit cover and undo both fastening screws.
3. Open the glasses compartment and undo both fastening screws.
4. Detach roof console around sliding roof switch on roof liner and allow it to hang down to the front.







5. Press electrical plug -4- on the compartment sensor -arrow a- and unplug.







6. Release sensor -arrows A- and remove from roof console -arrows B-.

Installing sensor for passenger compartment monitoring







1. Insert sensor into roof console frame -arrows A- until the locking lugs -arrows B- are felt to engage. Ensure it is seated properly.







2. Connect the electrical plug -arrow 4- until it clicks audibly into place.







3. Fold up roof console, clip it in the roof liner and screw down using the four fastening screws. Close the glasses compartment and clip in the light unit cover.

INFORMATION: After replacing the passenger compartment sensor, read out the fault memory from the central control unit for the comfort system (rear control unit) and then erase it.