Spark Plug: Service and Repair

Removing And Installing Spark Plugs

Tools







Technical values







Preliminary work

CAUTION:
Hot components
- Risk of burns
- Let hot components cool down.
- Wear personal protective gear.

1. Remove rear wheel.
Socket-wrench insert P300 should be used to avoid damaging the rims.

2. Remove rear silencer.
3. Remove upper part of heat shield.
3.1. Remove upper part of heat shield.

4. Remove ignition rod module.

Removal

Removing spark plugs

Component overview:







CAUTION:
Incorrect tool
- Risk of damage to components
- Use prescribed tool.







1. Remove spark plugs using spark-plug socket wrench Nr.14 and extension Nr.15 -1-.

Installation

Installing spark plugs

CAUTION:
Incorrect tool
- Risk of damage to components
- Use prescribed tool.







1. Fit spark plug using spark-plug socket wrench Nr.14 and extension Nr.15 and tighten to the specified tightening torque.
- Tightening torque: 32 Nm (24 ftlb.)
- Tightening torque: 25 Nm (19 ftlb.)+3 Nm (+2 ftlb.)

Subsequent work
1. Install ignition rod module.
- Tightening torque: 10 Nm (7.5 ftlb.)

2. Install upper part of heat shield.
2.1. Fit heat shield and screw in and tighten two M6 x 12 outer Torx screws (socket insert E10).
- Tightening torque: 10 Nm (7.5 ftlb.)

3. Install rear silencer.
4. Mount rear wheel.
Socket-wrench insert P300 should be used to avoid damaging the rims.