Checking and Topping Up Oil For Front Final Drive

Checking and topping up oil for front final drive





Preliminary work

Danger
Vehicle raised incorrectly.
^ Danger of fatal injury or material damage should the vehicle fall down.

- Raise the vehicle at the prescribed jacking points.

1. Jack and raise the vehicle at the prescribed jacking points.
2. Remove front underbody panelling.
3. Place oil collection pan under the transmission.

Checking and topping up oil for front final drive

Checking and topping up oil for final drive

1. Check and top up oil for final drive.
1.1. Unscrew oil filler screw -A-.
1.2. The oil level is correct if transmission oil emerges.

Warning
Hot fluid
^ Danger of scalding

- Let the fluid cool down.

- Wear personal protective gear.





Oil filler screw

1.3. If transmission oil does not emerge, the oil level in the final drive is too low.
1.3.1. Fill in transmission oil until oil emerges at the oil inlet bore.

Information
Fill only with oil approved by Porsche.

Warning
Hot fluid
^ Danger of scalding

- Let the fluid cool down.

- Wear personal protective gear.

1.4. Clean the oil filler screw, screw in with a new sealing ring and tighten it.

- Tightening torque: 28 Nm (21 ftlb.)

Subsequent work

1. Install front underbody panelling.
2. Lower the vehicle.