918819 Removing and installing console for telephone

WM 918819 Removing and installing console for telephone

Technical values





Removing console for telephone





Installation position

Information

Different holders for mobile phones or additional handsets are used in the various countries.

Variant 1
1. Remove the two caps -2- on the additional handset holder -1-.





Removing mounting plate

2. Unscrew the two fastening screws -3- for the additional handset holder and remove the holder -1-.
3. Disconnect electric connector on the mounting plate -a-.

Variant 2
1. Unscrew the two fastening screws -1- and remove the mounting plate -2-.





Unscrewing fastening screw -1-

2. Carefully unclip the cover -3- using a screwdriver.





Unclipping cap

3. Unscrew the fastening screw -4- and remove the carrier plate -5-.
4. Unscrew the fastening screw -6- and remove the trim panel -7-.





Unscrewing fastening screw and removing trim

5. Unscrew the three fastening screws -8- and remove the telephone console -9-.





Unscrewing fastening screw and removing telephone console

Installing console for telephone

1. Position the telephone console -9- and secure it with the three fastening screws -8-. => Tightening torque: 1.8 Nm (1.5 ftlb.)+/-0.5 Nm (+/-0.5 ftlb.)





Positioning and securing telephone console

2. Press the trim panel -7- onto the console and secure with the fastening screw -6-. => Tightening torque: 1.8 Nm (1.5 ftlb.)+/-0.5 Nm (+/-0.5 ftlb.)





Positioning trim and securing with the fastening screw

Information

Different holders for mobile phones or additional handsets are used in the various countries.

Variant 1
3. Insert electric connector for the additional handset holder until the connector engages securely.





Installing mounting plate

4. Position the additional handset holder and secure with the two fastening screws -1-. => Tightening torque: 1.8 Nm (1.5 ftlb.)+/-0.5 Nm (+/-0.5 ftlb.)

Variant 2
5. Fit the carrier plate -5- onto the console and secure with the fastening screw -4-. => Tightening torque: 1.8 Nm (1.5 ftlb.)+/-0.5 Nm (+/-0.5 ftlb.)





Positioning and securing carrier plate

6. Fit and clip in cap -4-.
7. Secure the mounting plate with the fastening screws -1-. => Tightening torque: 1.8 Nm (1.5 ftlb.)+/-0.5 Nm (+/-0.5 ftlb.)





Securing mounting plate

8. Place the handset in the console.