724819 Removing and Installing Back Seat

WM 724819 Removing and installing back seat

Technical values






Removing back seat





1. Unlock rear seats -1, 2- and fold up 90°.





2. Only in vehicles with seat heater:
Release plug -Arrow A- and pull it off -Arrow B-.





3. Unclip the connector -Arrow C-.





4. Unscrew fastening screws -3- , -3- and -3-.













5. Remove rear seats => see figure.






Installing back seat





CAUTION

Danger of material damage to seat bolts.

-> The fastening screws for seats are coated and must be replaced after being unscrewed.
-> Before screwing in the new fastening screws, clean the thread holes with an M 10 tap.

1. To position the rear seats, unfold hinge parts on the rear seats and place seats in a raised position => see figure.





2. Screw in fastening screws -3- , -3- and -3- and tighten to the specified tightening torque. => Tightening torque: 50 Nm (37 ftlb.)+10 Nm (+7.5 ftlb.)













3. Only for vehicles with seat heater: Clip in plug -Arrow A-.





4. Push on the connector -Arrow B- until the locking tabs engage audibly -arrows-.





5. Fold down rear seats -1, 2- and lock them.