Engine: Specifications

Cylinder head

Screw in twelve M10 Torx screws evenly and tighten.





Tightening sequence for cylinder-head screws





Camshaft housing to cylinder head

M6
Tightening torque 10 Nm (7.5 ftlb.)

Gear Carrier

Position 14 M9 x 127 thrust-bearing screws manually. Pre-tighten screws to the required tightening torque in accordance with the tightening sequence. Then tighten to the required torque angle.

Initial tightening 15 Nm (11 ftlb.)
Torque angle 120°





Tightening sequence for gear carrier

Connecting rod bolt





Belt pulley

Belt pulley to crankshaft
Initial tightening
Tightening torque 37 ftlb.
Final tightening
Torque angle 90°

Flywheel





Screw in and tighten fastening screws in diagonally opposite sequence.

Drive plate for torque converter

Initial tightening 25 Nm (19 ftlb.)
Torque angle 120°

Oil pump housing





Exhaust manifold

Fit exhaust manifold with new screws M8 x 26. Tighten screws from the inside out and in diametrically opposite sequence.

Tightening torque 23 Nm (17 ftlb.)

Coolant pump