Removing and Installing Trim Strip For the Instrument Panel

Removing And Installing Trim Strip For The Instrument Panel

Removing trim strip for the instrument panel

Removing trim strip for dashboard (on driver's side)







1. Insert a plastic wedge between the dashboard and left trim strip -1- and unclip trim strip.







2. Check clamp, replace if necessary.
3. Insert a plastic wedge between the dashboard and right trim strip -1- and unclip trim strip.







4. Check clamp, replace if necessary.

Removing trim strip for dashboard (central locking switch)

1. Switch off ignition and remove ignition key.
2. Insert a plastic wedge between the dashboard and centre trim strip -1- and unclip trim strip.
3. Hold trim strip and remove the switch -2- by unlocking the locking lugs.







4. Check clamp, replace if necessary.

Removing trim strip for dashboard (cup holder)

1. Open the glove compartment.
2. Insert a screwdriver between the cup holder -2- and left/right trim strip -1- and unclip cover carefully in -direction of arrow-.







3. Insert a screwdriver between the cup holder -2- and centre trim strip -1- and unclip cover carefully in -direction of arrow-.







Installing trim strip for the instrument panel

Installing trim strip for dashboard (cup holder)

1. Position centre trim strip -1- on the cup holder and press in until it clicks into place.







2. Position left/right trim strip -1- on the cup holder and press in until it clicks into place.







3. Close glove compartment.

Installing trim strip for dashboard (central locking switch)

1. Press switch -2- into the trip strip until the locking lugs engage.







2. Position trim strip -1- on the dashboard and press in until it clicks into place.

Installing trim strip for dashboard (on driver's side)

1. Position right trim strip -1- on the dashboard and press in until it clicks into place.







2. Position left trim strip -1- on the dashboard and press in until it clicks into place.