94311900 Removing and installing tail light

WM 943119 Removing and installing tail light

Technical values





Removing tail light





Installation position

1. Unscrew the three fastening nuts -1- for the tail light.





Unscrew fastening screw.

2. Pull out rear light, release the electric central connector for the rear light -A- and pull it off.





Releasing and pulling off connector

3. Take out rear light and release the plate for the bulbs -A- and remove.





Releasing the plate for the bulbs

Installing tail light

1. Push on the plate for the bulbs on the rear light until the plate clicks into place.
2. Check the seal for the rear light and if in doubt, replace.
3. Push the central connector for the tail light together until the connector is felt to engage.





Plugging in connector

4. Push the electric lead into the rear wing and insert the tail light into the mounting.
5. Screw down the rear light with the three fastening nuts -1-. => Tightening torque: 2 ftlb.





Screwing down the tail light

Information

Lamp overview: tail light





Lamp overview: tail light