P0560

P0560

Diagnosis information - DME V6 DFI

Power supply

NOTE:
- The fault P0560 is entered when an implausible supply voltage is detected later than 3 minutes after the end of engine start-up.
- The fault P0562 is entered when a supply voltage of under 10 V is detected later than 3 minutes after the end of engine start-up.
- The fault P0563 is entered when a supply voltage of over 17.04 V is detected later than 3 minutes after the end of engine start-up.

Diagnostic conditions
- Speed > 5 km/h (3 mph)
- No >vehicle speed< fault
- Time after engine starts > 60 seconds

Possible fault causes
- Malfunction of vehicle electrical system control unit
- Contact resistance in the lines
- Battery faulty
- Generator with regulator faulty

Affected contacts on the DFI control unit connector
Connector [B]:
- Contact 92
- Contact 69