355319 Removing and installing sealing ring for output shaft

WM 355319 Removing and installing sealing ring for output shaft

Tools






Preliminary work for sealing ring for output shaft

1. Remove transfer box. -> 396519 Removing and installing transfer box - section on "Removing" Service and Repair

Removing sealing ring for output shaft





Overview of output-shaft sealing ring

Information

- There are two depressions in the sealing ring. -arrows- The sheetmetal screws for removing the sealing ring are screwed in here.





Depression in sealing ring

1. Screw two sheetmetal screws into the sealing ring.





Preliminary work for removing the sealing ring

2. Remove sealing ring using slide hammer kit nr.168.





Removing sealing ring

Installing sealing ring for output shaft





Overview of output-shaft sealing ring

1. Fill the space between the dust and sealing lips on the new sealing ring with grease).





Preparing sealing ring

2. Push special tool protective sleeve t10186 -arrow- onto the output shaft.





Protective sleeve on output shaft

3. Push on sealing ring.
4. Remove special tool protective sleeve t10186 and drive sealing ring in flush using special tool pressure piece t10180 -arrow-.





Installing sealing ring

Subsequent work

Subsequent work for sealing ring for output shaft

1. Install transfer box. -> 396519 Removing and installing transfer box - section on "Installing" Service and Repair
2. Check transmission oil. -> 340135 Checking and topping up transmission oil - section on "Checking" Procedures