918819 Removing and Installing Console For Telephone

WM 918819 Removing and installing console for telephone

Technical values





Removing console for telephone





Overview of telephone console





One-sided view of installation kit for mobile phone console A-E





1. Release interface box -Arrow a- and pull it down and off.





Releasing and removing interface box

2. Unscrew the fastening screws for the interface box holder from the upper part -E-.
3. Unscrew fastening screw -4- from upper part -E- , raise upper part and leave it hanging forwards.





Unscrewing fastening screw and removing upper part

4. Unscrew fastening screw -3- from inner part-outer part -A, D- and pull side panel -A- to the left and leave it hanging out.





Unscrewing fastening screw and removing inner part

5. Undo the three fastening screws -2- from the clamp -B- and remove clamp.





Unscrewing fastening screw and removing clamp

6. Remove the outer part -D- together with cable duct -C- from the holder on the centre console.
7. Pull the VDA interface and antenna leads under the centre console -G- and disconnect them, then remove the upper part with cradle.





Disconnecting VDA interface and antenna leads






Installing console for telephone

Information

Lay the leads so that they are not pinched.

1. Fit the upper part -E- loosely to the outer part -D- and lay the VDA interface lead and antenna lead in the outer part -D-.





Laying VDA interface and antenna leads

2. Engage the cable duct -C- in the outer part -D-.
3. Lift the assembled components -C, D, E- onto the centre console holder, engage the cable duct at the lower edge of the centre console, and push the components -C, D, E- onto the centre console holder.





Pushing components onto centre console holder and screwing down

4. Place the clamp on the outer part and secure with the three fastening screws -2-. => Tightening torque: 1.5 ftlb.
5. Engage the inner part -A- with the outer part -D- , then clip into the outer part and secure with the fastening screw -3-. => Tightening torque: 0.5 ftlb.





Fastening inner part

6. Engage the upper part -E- in the inner-outer part -A, D- and secure with the fastening screw -4-. => Tightening torque: 0.5 ftlb.





Fastening upper part

7. Drill hole in cover and insert fastening screw -1- for the interface box holder in the upper part -E-. => Tightening torque: 0.5 ftlb.





Drilling cover and securing holder for interface box

8. Push the interface box onto the cradle from below until the interface box engages.





Pushing interface box from below

9. Connect wiring for the VDA interface and antenna leads





Connecting VDA interface and antenna leads





10. Raise the centre console and push the wiring under it.
11. Move the seat to the position required by the customer.