Operation CHARM: Car repair manuals for everyone.

2706 External Power Connection, Jump Lead Starting


WM 270600 External power connection, jump lead starting

Information

1. Remove cover for jump lead starting terminal.





Removing the cover.

2. Open protective cover on the positive terminal -+- for jump lead starting -arrow A-.





Protective cover on positive terminal for jump-lead starting

3. Connect the positive cable to the positive terminal for jump-lead starting -+- , then to the positive terminal of the battery supplying the power.
4. First, connect the negative cable to the negative terminal of the battery supplying the power, then to the ground point for jump-lead starting - - -.
5. Have the engine of the vehicle supplying the power run at a higher speed.
6. Start engine. Do not spend longer than 15 seconds trying to start the vehicle with the jump leads - after 15 seconds have elapsed, wait for at least one minute.
7. Disconnect the two jump leads in reverse sequence when the engine is running.
8. Close protective cover -arrow B-.
9. Position the cover.





Positioning the cover