74491901 Removing and installing padding for 1/3-split folding rear seat

WM 744919 Removing and installing padding for 1/3-split folding rear seat

Removing padding for 1/3 split folding rear seat









1. Remove rear seat. -> 724819 Removing and installing rear seat - section on "Removing" 724819 Removing and installing rear seat (single-seat look)
2. Lever out seal -2- on cover for rear seat -1- by inserting a plastic wedge into the front right corner -Arrow A-.





3. Pull piping -2- of cover for rear seat -1- out completely in direction of arrow.





4. Release wire harness for seat heater (only for vehicles with seat heater): Press grommet -3- with connector -4- out of the seat frame -Arrow B-.





5. Remove padding: Remove seat frame -5- from padding with cover -1- -Arrow C-.





6. Remove cover for seat -> 745019 Removing and installing cover for rear seat - section on "Removing" Service and Repair

Installing padding for 1/3 split folding rear seat





1. Install cover for rear seat. -> 745019 Removing and installing cover for rear seat - section on "Installing" Service and Repair
2. Fasten wire harness for heated seats (only for vehicles with heated seats): Insert connector -4- into the seat frame and fit the grommet -3- -Arrow A-.





3. Install padding: Place seat frame -5- on the padding with cover -1- and align -Arrow B-.





4. Press piping -2- of cover for rear seat -1- completely into the seat frame in direction of arrow -Arrow C-.









5. Install rear seat. -> 724819 Removing and installing rear seat - section on "Installing" 724819 Removing and installing rear seat (single-seat look)