726719 Removing and installing mount for rear backrest

WM 726719 Removing and installing mount for rear backrest

Technical values





Preliminary work

Remove cover for rear backrest. -> 745319 Removing and installing cover for rear backrest - section on "Removing" 745319 Removing and installing cover for rear backrest

Removing mount for rear backrest





Installation position of mount

1. Use a suitable tool to prevent the M12 fastening nuts -3- from turning.
2. Unscrew inner -1- and outer bearing pins -2- with the bearing sleeves.
3. Remove inner -1- and outer mount -2-.





Removing mount

Removing mount for backrest (with armrest)





Installation position of mount (with armrest)

1. Use a suitable tool to prevent the M12 fastening nut -3- from turning.
2. Unscrew inner -1- and outer bearing pins -2- with the bearing sleeves.
3. Remove inner -1- and outer mount -2-.





Removing mount

Removing mount for rear backrest (with load-through system)





Installation position of mount (with load-through system)

1. Use a suitable tool to prevent the M12 fastening nut -3- and the load-through sleeve -4- from turning.
2. Unscrew inner -1 - and outer bearing pins -2 - with the bearing sleeves.
3. Remove inner -1 - and outer mount -2-.





Removing mount

Installing mount for rear backrest

1. Position inner and outer bearing pins with the bearing sleeves.
2. Use a suitable tool to prevent the M12 fastening nuts -3- from turning.
3. Screw in bearing pins -1 and 2- and tighten to the specified tightening torque. => Tightening torque: 50 Nm (37 ftlb.)+/-5 Nm (+/-3.5 ftlb.)





Tightening bearing pins

Installing mount for backrest (with armrest)

1. Position inner and outer bearing pins with the bearing sleeves.
2. Use a suitable tool to prevent the M12 fastening nut -3 - from turning.
3. Screw in bearing pins -1 and 2- and tighten to the specified tightening torque. => Tightening torque: 50 Nm (37 ftlb.)+/-5 Nm (+/-3.5 ftlb.)





Tightening bearing pins

Installing mount for rear backrest (with load-through system)

1. Position inner and outer bearing pins with the bearing sleeves.
2. Use a suitable tool to prevent the M12 fastening nut -3- and the load-through sleeve -4- from turning.
3. Screw in bearing pins -1 and 2 - and tighten to the specified tightening torque. => Tightening torque: 50 Nm (37 ftlb.)+/-5 Nm (+/-3.5 ftlb.)





Tightening bearing pins

Subsequent work

Fit cover for rear backrest. -> 745319 Removing and installing cover for rear backrest - section on "Installing" 745319 Removing and installing cover for rear backrest